PRODUCTS- 產品介紹 -

6點類比輸入,2點類比輸出,3點數位輸入和3點數位輸出 M-7026



 產品型錄(PDF)

 
Analog Input
Channels 6
Wiring Differential
Range ±150 mV, ±500 mV, ±1 V, ±5 V, ±10 V
±20 mA , 0 ~ 20 mA, 4 ~ 20 mA(Jumper Selectable)
Resolution 16-bit
Accuracy Normal Mode ±0.1% of FSR
Fast Mode ±0.5% or better
Sampling Rate Normal Mode 10 Samples/Sec.
Fast Mode 60 Samples/Sec. (Total)
Bandwidth Normal Mode 15.7 Hz
Fast Mode 78.7 Hz
Input Impedance Voltage 2 MΩ
Currnet 140 Ω
Common Voltage Protection ±200 V 
Individual Channel Configuration Yes
Overvoltage Protection 240 Vrms
Overcurrent Protection Yes, 50 mA at 110 VDC
Virtual Channel to Channel Isolation Yes,400 VDC
Open Wire Detection for 4 ~ 20 mA Yes
Analog Output
Channels 2
Range +0 ~ +5 VDC, +0 ~ +10 VDC, ±5 VDC, ±10 VDC,
+0 ~ +20 mA, +4 ~ +20 mA (Jumper Selectable)
Resolution 12-bit
Accuracy ±0.1% of FSR
Output Capacity
Voltage Output Capability
10 V @ 20 mA
Open Wire Detection Yes, for 4 ~ 20 mA only
Power-on Value Yes, Programmable
Safe Value Yes, Programmable
Digital Input/Counter
Channels 3
Type Dry Contact Source
Wet Contact -
Wet Contact On Voltage Level -
Off Voltage Level -
Dry Contact On Voltage Level Close to GND
Off Voltage Level Open
Counters Max. Count 65535 (16-bit)
Max. Input Frequency 50 Hz
Min. Pulse Width 5 ms
Input Impedance -
Channel-to-Channel Isolation -
Overvoltage Protection -
Safe Value Yes, Programmable
Digital Output
Output Channels 3
Type Open Collector
Sink/Source (NPN/PNP) Sink
Load Voltage + 3.5 VDC ~ + 50 VDC
Max. Load Current 700 mA/Channel
Overvoltage Protection 60 VDC
Overload Protection Yes
Short-circuit Protection Yes
Power-on Value Yes, Programmable
Safe Value Yes, Programmable
 
Communication
Interface RS-485
RS-485 Bias Resistor No (An RS-485 master is required to provide the bias.)
Format N, 8, 1
Baud Rate 1200 ~ 115200 bps
Protocol Modbus RTU, DCON
Dual Watchdog Yes, Module (1.6 Seconds), Communication (Programmable)
LED Indicators/Display
System LED Indicator Yes, 1 LED as Power/Communication Indicator
I/O LED Indicators -
7-Segment LED Display - 
Isolation
Intra-module Isolation,
Field-to-Logic
2500 VDC
EMS Protection
ESD (IEC 61000-4-2) ±4 kV Contact for each Terminal
±8 kV Air for random point
EFT (IEC 61000-4-4) ±4 kV for Power Line
Surge (IEC 61000-4-5) ±3 kV for Power Line
Power
Reverse Polarity Protection Yes
Input Range 10 ~ 30 VDC
Consumption 1.8 W
Mechanical
Dimensions (W x L x H) 72 mm x 123 mm x 35 mm
Installation DIN-Rail or Wall Mounting
Environment
Operating Temperature -25 ~ +75°C
Storage Temperature -40 ~ +85°C
Humidity 10 ~ 95% RH, Non-condensing